Voice Contolled Robot

My voice controlled robot is a robot that I built that is able to recognize speech to move in a variety of directions as well as being controlled using an app I created

Engineer

Hunter A

Area of Interest

Computer Science/Mechanical Engineering

School

KIPPNYC College Prep

Grade

Rising Sophmore

Second Milestone

*Input Second Milestone*

First Milestone

My first milestone was to complete the chassis as well as connect power to the motors. Completing the chassis was difficult due to the fragility of the main body, their was a lot of trial and error in getting everything built without a part breaking for the 3rd time. But I feel as though it taught me a valuable lesson, that being that you have to push through a lot of setbacks and problems especially in this field. Other than that connecting the battery to the motors was pretty simple, so there wasn’t many problems aside from me almost frying the circuit by switching the polarity

Completing the chassis and getting power to the motors is the first step in completing the voice controlled robot, which is my main project, for my milestone I had to learn how to use a breadboard. A breadboard is a solder-less device for temporary prototype with electronics and test circuit designs, which essentially means I can create circuits that aren't permanent meaning I can change the circuit depending on what I need. This is great for someone like me who is new to engineering and circuity. To connect the motor to the breadboard I had weld wires to the motor on one side and and connect the other side to the breadboard. Once I got the battery connected I was able to get the motors running.  The chassis was pretty simple in comparison to the breadboard and the circuity because it came as a kit, although a certain part did break a few times and gave me trouble.

Starter Project : MintyBoost

My Starter project is the MintyBoost, a battery powered portable charger for your phone. This project was enjoyable because it showed me how to work with things like solder, and also taught me to not give up when something goes wrong, learn from my mistakes and keep pushing till I succeed.

Demonstration

How does it work

The MintyBoost is powered by two 1.5v batteries. The resistors on the circuit keep the voltage from overloading the circuit. The power from the battery is kept in a current created by the inductor. The inductor is a coil wrapped around metal wire and when the current hits the inductor it creates a magnetic field. The boost convertor chip controls a switch in the current, when the switch is flipped the magnetic field partially collapses which sends the voltage to an alternate current. The collapse of the field ups the voltage of the current, and send it through a diode- A diode makes sure the current doesn’t go backwards- and the diode sends it to the capacitor, where it’s stored until its needed to charge your phone.

These are the instructions

MintyBoost Schematic

adafruit_products_mintyboostv3sch
Image Source: https://github.com/adafruit/Adafruit-MiniPOV4-Kit/tree/master/Hardware

Start typing and press Enter to search